![]() By using the EMM386.EXE the drivers can be loaded in High Memory, leaving almost all of the Convention memory for the installation.Īdditionally, you should copy the MSDOS.SYS to the disk as a backup. This can leave insufficient memory for the Windows Installation program. When you select "CD-ROM Support" from the boot menu on the disk, the drivers for the CDROM must load in conventional Microsoft also did not put EMM386.EXE on the disk and use it. But Microsoft did not include the MEM.EXE on the disk. I have had memory errors, and have read of others who also had these errors, when using this boot disk. I recommend adding the following 2 files: When you create a Startup Disk with Windows 98 the following files are copied to the floppy: I set the disk to load all of the drivers high. I got that result on a Packard Bellģ86x25 (16mb ram), a Packard Bell 486x75 (8mb ram), and a Tyan Tomcat III pentium 200. With the modificaions I recommend here, you can load the CD-ROM and a parallel port ZIP Drive and have 624K of available Conventional memory. The Conventional memory will be 550k or less. If you are installing Windows, the install mayįail due to lack of memory because of these drivers. If it succeeds, that driver as well as the MSCDEX.EXE are loaded in conventional memory. When youĬhoose "CD-ROM Support" from the menu, various drivers are tested to try to find one that will works with your CD-ROM. The Windows 98 Startup Disk has a boot menu which allows you to choose to load or not load the CDROM. The IO.SYS of Windows 95 and later accomplishes the functions On versions before Windows 95, if the AUTOEXEC.BAT is not present, the system will ask for the time and date at boot. It is, therefore, called the command interpreter. This provides a language for you to use that you understand, and it translates it into the language that the computer understands. Since then it has become just an INI file, similar to the CONFIG.SYS and AUTOEXEC.BAT files. This file continued the programming before Window 95 was introduced. This file gives the computer its instructions for interpreting data. ![]() When a computer boots with MS-DOS it first loads the file: The Boot files are located in a specific area of the disk and the Boot Sector of the disk identifies the disk as bootable Making a boot disk is not simply copying files to a disk. But you have to have a computer capable of CDROM Boot to take advantage of that. The exception may be Windows 98 where some are on Bootable CDROMs. You cannot access the files on any of these if you have no way to boot theĬomputer. Windows 3.x normally installs from floppy disks. Windows 95 and 98 normally install from a CDROM. Your computer becomes un-bootable, you are in trouble. It is only a tool to get your system running so you can make repairs. But in some instances, they are inadequate also.Ī Startup Disk is not a backup of your system. Windows 98 Startup Disks are more complete. Windows 95 and later makes that pretty easy. Once your system is operating correctly you should make a Startup Disk. Links to other sources for bootdisks and information Getting more files on your bootdisk (compression) What should be in the CONFIG.SYS and AUTOEXEC.BAT files Adding an Iomega ZIP Drive to your Startup Disk
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |